Removing The Front Bezel And The Top Cover - Nortel Contivity 2600 Getting Started

Removing the front bezel and the top cover

To install LAN, WAN, or Hardware Accelerator cards or to install additional
memory, you must remove the Contivity's front bezel and then you must remove
the Contivity's top cover.
To remove the front bezel and cover you need a Phillips screwdriver. Note that you
do need to turn off the Contivity to remove the top cover.
1
Turn off the Contivity's power and unplug it.
2
Using the Phillips screwdriver, turn each of the two screws on the front bezel a
quarter turn counter-clockwise as shown in
3
Grip the two handles and firmly pull the bezel towards you to unsnap it from
the chassis. Do not use the piece with the Nortel Networks logo and the LEDs
as a handle.
4
Using the Phillips-head screwdriver, remove the four screws that secure the
cover to the chassis as show in
Chapter 4 Changing Hardware Configurations 47
Figure
19Figure 19.
Getting Started with the Contivity 2600
18.