Installing The Chassis In An Equipment Rack; Figure 2 Placement Of Rubber Feet On The Bottom Of The Chassis - Nortel Contivity 5000 Installing

26 Chapter 1 Installing the Contivity 5000 chassis
The Contivity 5000 accessory kit includes four rubber feet that can be attached to
the bottom of the chassis.

Figure 2 Placement of rubber feet on the bottom of the chassis

Installing the chassis in an equipment rack

To mount the Contivity 5000 in an equipment rack, you need the following
equipment:
•
•
•
•
315990-D Rev 00
Attach feet (4)
Standard four-post 19-inch equipment rack
Caution: Install the Contivity 5000 in a four-post rack only.
12 screws (supplied with the chassis)
8 cage nuts (supplied with the chassis) if the rack does not have threaded holes
#2 Phillips screwdriver
Figure 2 shows the placement of these rubber feet.
CS160016A