Table of Contents
Advertisement
SureCross DX80 FlexPower Thermocouple Node
LED 1
For Gateway and Ethernet Bridge systems, active Modbus communication refers to the communication between the Gateway and the
Ethernet Bridge. For GatewayPro systems, the Modbus communication LEDs refer to the communication internal to the Gateway Pro.
For Gateway only systems, the Modbus communication LEDs refer to the communication between the Gateway and its host system (if
applicable).
When testing the Gateway and Node, verify all radios and antennas are at least two meters apart or the communications may fail.
Specifications
Radio
Range
900 MHz: Up to 4.8 kilometers (3 miles) *
2.4 GHz: Up to 3.2 kilometers (2 miles) *
Transmit Power
900 MHz: 21 dBm conducted
2.4 GHz: 18 dBm conducted, less than or equal to 20
dBm EIRP
900 MHz Compliance (150 mW Radios)
FCC ID TGUDX80 - This device complies with FCC
Part 15, Subpart C, 15.247
IC: 7044A-DX8009
2.4 GHz Compliance
FCC ID UE300DX80-2400 - This device complies with
FCC Part 15, Subpart C, 15.247
ETSI/EN: In accordance with EN 300 328: V1.7.1
(2006-05)
IC: 7044A-DX8024
General
Power*
Requirements: +10 to 30V dc or 3.6 to 5.5V dc low
power option (For European applications: +10 to 24V
dc, ± 10% or 3.6 to 5.5V dc low power option)
Consumption: Less than 1.4 W (60 mA) at 24V dc
Housing
Polycarbonate
Weight: 0.26 kg (0.57 lbs)
Mounting: #10 or M5 (M5 hardware included)
Max. Tightening Torque: 0.56 N·m (5 in·lbf)
Inputs
Discrete Inputs
Rating: 3 mA max current at 30V dc
Sample Rate: 1 second
P/N 131297 rev. I
LED 2
(yellow flashing)
(red flashing)
www.bannerengineering.com - tel: 763-544-3164
Gateway Status
Modbus Communication Active
Modbus Communication Error
Spread Spectrum Technology
FHSS (Frequency Hopping Spread Spectrum)
Antenna Connection
Ext. Reverse Polarity SMA, 50 Ohms
Max Tightening Torque: 0.45 N·m (4 in·lbf)
Link Timeout
Gateway: Configurable
Node: Defined by Gateway
* With the standard 2 dB antenna. High-gain antennas are availa-
ble, but the range depends on the environment and line of sight.
To determine the range of your wireless network, perform a Site
Survey.
Interface
Indicators: Two bi-color LEDs
Buttons: Two
Display: Six character LCD
Wiring Access
Four PG-7, One 1/2-inch NPT, One 5-pin Euro-style
male connector
* For European applications, power the DX80 from a Limited Pow-
er Source as defined in EN 60950-1.
Thermocouple Inputs
Sample Rate: 1 second
Report Rate: 16 seconds
Node Status
No radio link (when flashing
once every three seconds)
9
Advertisement
Table of Contents
