Table of Contents
Advertisement
SureCross DX80 FlexPower Thermocouple Node
Mounting Hardware Kit
PTFE Tape
Antenna **
SureCross Literature CD
SureCross Quick Start Guide
Cable *
IP20 Screw Terminal Headers (2
pack) ***
* Not included with IP20 DX80...C models.
** Internal antenna devices do not ship with this antenna.
*** Not included with IP67 DX80 models.
Warnings
The manufacturer does not take responsibility for the violation of any warning listed in this document.
Make no modifications to this product. Any modifications to this product not expressly approved by Banner Engineering could void the
user's authority to operate the product. Contact the Factory for more information.
All specifications published in this document are subject to change. Banner reserves the right to modify the specifications of prod-
ucts without notice. Banner Engineering reserves the right to update or change documentation at any time. For the most recent version of
any documentation, refer to our website: www.bannerengineering.com. © 2006-2010 Banner Engineering Corp. All rights reserved.
Antenna Installation
Always install and properly ground a qualified surge suppressor when installing a remote antenna system. Remote antenna configura-
tions installed without surge suppressors invalidate the manufacturer's warranty.
Always keep the ground wire as short as possible and make all ground connections to a single-point ground system to ensure no ground
loops are created. No surge suppressor can absorb all lightning strikes. Do not touch the SureCross™ device or any equipment connec-
ted to the SureCross device during a thunderstorm.
Exporting SureCross Radios
It is our intent to fully comply with all national and regional regulations regarding radio frequency emissions. Customers who want to re-
export this product to a country other than that to which it was sold must ensure the device is approved in the destination
country. A list of approved countries appears in the Agency Certifications section of the product manual. The SureCross wireless prod-
ucts were certified for use in these countries using the antenna that ships with the product. When using other antennas, verify you are not
exceeding the transmit power levels allowed by local governing agencies. Consult with Banner Engineering if the destination country is
not on this list.
Banner Engineering Corp Limited Warranty
Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of
shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture which, at the time it is returned
to the factory, is found to have been defective during the warranty period. This warranty does not cover damage or liability for misuse,
abuse, or the improper application or installation of the Banner product.
P/N 131297 rev. I
1
1
BWA-HW-001
4
4
4
4
BWA-HW-003
1
BWA-9O2-C, or
1
BWA-2O2-C
79685
1
128185
1
MQDC1-506
1
BWA-HW-011
1
www.bannerengineering.com - tel: 763-544-3164
Plug, 1/2" NPT
Nylon gland fitting, 1/2" NPT
Screw, M5-0.8 x 25mm, SS
Screw, M5-0.8 x 16mm, SS
Hex nut, M5-0.8mm, SS
Bolt, #8-32 x 3/4", SS
Antenna, 902-928 MHz, 2 dBd Omni, Rubber Swivel RP-SMA
Male, or Antenna, 2.4 GHz, 2 dBd Omni, Rubber Swivel RP-
SMA Male
(Ships with Gateways)
Cable, 5-Euro (single ended), Straight, 2m
11
Advertisement
Table of Contents
