Hardware Installation; Caution Of Static Electricity - Boser HS-6200 Manual

Chapter-2

Hardware Installation

This chapter provides the information on how to install the hardware
of HS-6200/6600. At first, please follow up sections 1.3, 2.1 and 2.2
in check the delivery package and carefully unpacking. Following
after, the jumpers setting of switch, watchdog timer and the
DiskOnChip™ address selection etc.

2.1 Caution of Static Electricity

The HS-6200/6600 has been well package with an anti-static bag in
protect its sensitive computer components and circuitry from the
damage of static electric discharge.
Note: DO NOT TOUCH THE BOARD OR ANY OTHER
SENSITIVE COMPONENTS WITHOUT ALL NECESSARY
ANTI-STATIC PROTECTION.
You should follow the steps as following to protect the board in
against the static electric discharge whenever you handle the board:
1. Please use a grounding wrist strap on whoever needs to handle
the HS-6200/6600. Well clip the ALLIGATOR clip of the strap to
the end of the shielded wire lead from a grounded object. Please
put on and connect the strap before handle the HS-6200/6600 for
harmlessly discharge any static electricity through the strap.
2. Please use anti-static pad for put any components or parts or tools
on the pad whenever you work on them outside the computer.
You may also in use the anti-static bag instead the pad. Please
ask from your local supplier in help up your necessary parts on
anti-static requirement.
8