Table of Contents
Advertisement
Chapter-2
Hardware Installation
This chapter provides information on how to install the hardware of
HS-6301. Read sections 1.3, 2.1 and 2.2 about the delivery package and
unpacking information. Afterwards, pay attention to the jumpers setting of
switch, Watch-Dog Timer and the DiskOnChip
2.1 Caution of Static Electricity
The HS-6301 has been well packaged with an anti-static bag to protect
sensitive components and circuitry from damage caused by static electric
discharge.
Note：DO NOT TOUCH THE BOARD OR ANY OTHER SENSITIVE
COMPONENTS WITHOUT THE NECESSARY ANTI-STATIC
PROTECTION.
You should follow the steps below to protect the board against static
electric discharge whenever you handle the board：
1. Please use a grounding wrist strap on whoever needs to handle the
HS-6301. Clip the ALLIGATOR clip of the strap to the end of shielded
wire lead from a grounded object. Put on and connect the strap before
handling the HS-6301 to harmlessly discharge any static electricity
through the strap.
2. Please use an anti-static pad to put any components or parts or tools
on the pad whenever you work on them outside the system. You may
also use an anti-static bag instead of the pad. Please ask your local
supplier for assistance regarding anti-static requirements.
10
TM
address selection etc.
Advertisement
Table of Contents
