Hardware Installation; Caution Of Static Electricity - Boser HS-6036 User Manual

Chapter-2

Hardware Installation

This chapter provides the information on how to install the hardware
of HS-6036. First, proceed with sections 1.3, 2.1 and 2.2 to check
the delivery package. Then, proceed with the jumpers setting of
switches, Watch-Dog Timer and the DiskOnChip address
selection etc.
Please be advised that we have upgrade HS-6036 v2.1 to support
Tualatin CPU by selecting JP10. Please refer Jumper Setting P.14.

2.1 Caution of Static Electricity

The HS-6036 has been well packaged with an anti-static bag to
protect sensitive computer components and circuitry from the
damage of static electric discharge.
Note: DO NOT TOUCH THE BOARD OR ANY OTHER
SENSITIVE COMPONENTS WITHOUT ALL NECESSARY
ANTI-STATIC PROTECTION.
Follow the steps below to protect the board in against the static
electric discharge whenever you handle the board:
1. Use a grounding wrist strap in handling the HS-6036. Clip the
ALLIGATOR clip of the strap to the end of the shielded wire lead
from a grounded object. Please put on and connect the strap
before handle the HS-6036 for harmlessly discharge any static
electricity through the strap.
2. Use an anti-static pad to place any components or parts or tools
on whenever working on them outside the computer. You may
also in use the anti-static bag instead the pad. Please ask from
your local supplier for your needs on anti-static requirement.
8