Hardware Installation; Caution Of Static Electricity - Boser HS-4010 Manual

Chapter-2

Hardware Installation

This chapter provides the information on how to install the
hardware of HS-4010. At first, please follow up sections 1.3, 2.1
and 2.2 in check the delivery package and carefully unpacking.
Following after, the jumpers setting of switch, watchdog timer,
and the DiskOnChip? address selection.

2.1 Caution of Static Electricity

The HS-4010 has been well package with a anti-static bag in
protect its sensitive computer components and circuitry from
the damage of static electric discharge.
Note: DO NOT TOUCH THE BOARD OR ANY OTHER
SENSITIVE COMPONENTS WITHOUT ALL
NECESSARY ANTI-STATIC PROTECTION.
You should follow the steps as following to protect the board in
against the static electric discharge whenever you handle the
board:
1. Please use a grounding wrist strap on whoever needs to
handle the HS-4010. Well clip the ALLIGATOR clip of the
strap to the end of the shielded wire lead from a grounded
object. Please put on and connect the strap before handle the
HS-4010 for harmlessly discharge any static electricity
through the strap.
2. Please use anti-static pad for put any components or parts or
tools on the pad whenever you work on them outside the
computer. You may also in use the anti-static bag instead the
8