Setting The Rtc Configuration; System Memory Dram; Setting The Flat Panel Voltage - Boser HS-6200 Manual

2.10 Setting the RTC Configuration

The HS-6200/6600 provides a setting for the selection of the RTC
Clear Jumper by JP7 setting as following:
CMOS Setting of JP7:
l
CMOS Clear Jumper
Clear CMOS

2.11 System Memory DRAM

The HS-6200/6600 provides a wide range on-board DRAM memory
by two pieces DIMM sockets (DIMM-1, DIMM-2) request the access
time should meet PC-100 standard. The maximum capacity of the
on board memory is 1GBytes.
See the figure on section 2.3 for get the identifying the banks.

2.12 Setting the Flat Panel Voltage

The HS-6200/6600 provides a setting for the selection of the
working voltage of individual flat panel by JP11 setting as following:
Flat Panel Voltage Selecting of JP11:
l
Panel's Working Voltage JP11
Please contact with your flat panel supplier for make sure a correct
Panel's Working Voltage. Any mistake will cause defect to your flat
panel.
Normal
5.0 V
3.3 V
JP7
* OFF
ON
* 2-3
1-2
15