Table of Contents
Advertisement
CAUTION!
If the device is installed in areas
where there is a risk of frost or
outdoors, residual frozen water can
damage the device and frozen hoses
can tear or burst.
Do not use the device in areas where there is a risk of frost
▶
Set up and operate in areas or
outdoors.
The device was subjected to a function
test before it left the factory and may
contain residual water. If the device is
tilted over 40 °, this residual water can
leak out.
Tilt the device carefully.
▶
Installation site
On a sun-
ckel
On a wooden
beam ceiling
requirements
The device with
Retaining tabs
→
Page 39 loading
consolidate.
Place the device
on a water-
standing wooden
set up the plate,
which are firmly
attached to the floor
is screwed. the
Strength of wood
plate should min-
at least 30 mm
be.
Set up and connect de
Installation site
In a kitchen ¡ It's a line width
On a wall
4.4 Remove the transport
locks
The device is secured for transport
with transport locks on the back of
the device.
Hints
¡ Note the information
on the subject of security → page 4
and avoid property damage
→
Page 11, to keep your device safe
need to be able to.
¡ Keep the transport safety
stanchions, screws and sleeves
for later transport → Page 74 on.
requirements
from 60 cm
conducive.
¡ The device only
under one
go through-
the working
set up plate
len that stuck
with the
bar cabinets
connected is.
No hoses
between wall
and device on
clamp.
15th
Advertisement
Table of Contents
