Table of Contents
Advertisement
disturbance
flashes.
shines.
flashes.
All other fault co-malfunction
of.
Device works
not.
Program starts
not.
Cause and troubleshooting
If the voltage drops below this limit, the program can
be extended.
No fix possible.
Detergent dosage is too high.
Immediate action: Mix one tablespoon
▶
Softener with 0.5 liters of water and pour the
mixture into the compartment for manual dosing
(not for outdoor, sportswear and down textiles).
When intelligent dosing is activated,
▶
like the basic dosage → Page 49.
If you dose manually, decrease the
▶
the amount of detergent for the next wash cycle
with the same load.
Temperature is too high.
Wait until the temperature has dropped.
▶
→ " Abort program ", page 46
▶
The water level is too high.
Start the program Pumping out.
▶
Laundry is jammed in the door.
Open the door again.
1.
Remove jammed laundry.
2.
Close the door.
3.
To start the program, press
4th
Door is not closed.
Close the door.
1.
To start the program, press
2.
Call customer service.
▶
→
"Customer service", page 76
The mains plug of the mains connection cable is not
plugged in.
Connect the device to the mains.
▶
The fuse is defective.
Check the fuse in the fuse box.
▶
Power supply has failed.
Check whether the room lighting or other
▶
Devices in the room work.
was not pressed.
Press .
▶
Troubleshooting de
.
.
65
Advertisement
Table of Contents
