Siemens WM14UP40 Instructions For Use And Assembly page 67

disturbance
The detergent solution does not come out. Drain pipe or water drainage hose is blocked.
pumped out.
Water does not run in. Detergent won't
Press
▶
washed in.
Cause and troubleshooting
Clean the drain pipe and water drain
▶
running hose.
The drain pipe or water drainage hose is kinked or
pinched.
Make sure the drain pipe and the
▶
The water drainage hose is not kinked or trapped.
The drain pump is blocked.
→ " Cleaning the drain pump ", page 57
▶
is activated.
Continue the program by pressing Sluice
▶
change or Pumping out select and press.
The water drainage hose is connected too high.
Mount the water drainage hose in maxi-
▶
times 1 meter in height.
Detergent dosage is too high.
Immediate action: Mix one tablespoon
▶
Softener with 0.5 liters of water and pour the
mixture into the compartment for manual dosing
(not for outdoor, sportswear and down textiles).
When intelligent dosing is activated,
▶
like the basic dosage → Page 49.
If you dose manually, decrease the
▶
the amount of detergent for the next wash cycle
with the same load.
Inadmissible extension mounted on the water
drainage hose.
Remove impermissible extensions from the water
▶
drain hose. Connect device
was not pressed.
The filters in the water inlet are blocked.
Clean the filters in the water inlet → Page 60.
▶
The tap is closed.
Open the faucet.
▶
The water inlet hose is kinked or pinched.
Make sure that the water inlet hose
▶
is not kinked or pinched.
Troubleshooting de
.
67