Command Description - Nortel Express Installation Manual

Respond to the prompts as shown in the following table. If a prompt
appears that is not in the table, press Enter to accept the default value:
Command
ENLC l s c
ENLU l s c u
DISC l s c
DISU l s c u
STAT l s c
STAT l s c u
Type **** to exit from the overlay.
Log off the M1, M1 IE, or Succession CSE 1000 switch.
To replace a Voice Services card in the switch
Use this procedure to replace the Voice Services card in the switch. Ensure you
make the changes in a scheduled maintenance slot.
A replacement Voice Services card ships without a dongle, a PCMCIA card, and
DSP cards. You transfer the dongle, PCMCIA card, and DSP cards from the
original Voice Services card to the new card.
ATTENTION
Based on the type of cable connection, you must disconnect the cable from
the backplane:
a. Disconnect the backplane cable, which connects the IPE shelf
Description
Enables the Voice Services card.
Enables a unit (Voice Services port).
Disables the Voice Services card.
Disables a unit (Voice Services port).
Displays the status of the card and a brief status of all
units.
Displays the status of one unit (Voice Services port).
Before you replace a Voice Services card in the switch,
you must shut down the Voice Services service from
the Symposium Express Call Center.
backplane to the corresponding port on the I/O panel.