Nortel Express Installation Manual page 28

To determine the loadware version
Log on to the Voice Services card, and then run the command swInfoGet.
example:
To upgrade the loadware
Use this procedure to upgrade the Voice Services application loadware if
commissioning the card for the first time. If you are not commissioning the card
for the first time, ensure you make the changes in a scheduled maintenance slot.
To upgrade the loadware, follow this procedure on the Symposium Express Call
Center server:
From the Windows Start menu, choose Programs
Type ftp, and then press Enter.
Type open aaa.bbb.ccc.ddd, and then press Enter.
Type vpsdseuser, and then press Enter.
Enter the appropriate password, and then press Enter.
Initiate a HyperTerminal session with the Voice Services card.
To check the current directory, at the
Enter. This checks the present working directory. The directory should be
the drive in which you inserted the PCMCIA card. If it is not, type cd "/X:",
(where X: is the proper directory), and then press Enter.
The swInfoGet command indicates the version. The following is an
-> swInfoGet
SECC Voice Services Rev: 01:04
DSP 0 Software Stream: NG0303_ Date: 990920
DSP 1 Software Stream: NG0303_ Date: 990920
*Dsp Card in slot 2 not inserted
value = 0 = 0x0
-> XA Firmware Release: (null)
The MSDOS Prompt window appears.
aaa.bbb.ccc.ddd is the IP address of the Voice Services card.
The password> prompt appears.
You must type the double quotes.
MSDOS Prompt.
prompt, type pwd, and then press