Nortel Express Installation Manual page 34

Repeat this procedure for each Voice Services port that corresponds to the
ACD.
Load Overlay 43 by typing LD 43.
Type EDD to execute a data dump to back up the data you entered.
Log off the M1, M1 IE, or Succession CSE 1000 switch.
To enable or disable Voice Services ports
Use LD 32 overlay to enable and disable the Voice Services card. You also use
LD 32 overlay to check the port status.


Nortel Networks recommends that the operator disable all Voice Services
card digital units in LD 32 before moving (MOV) or removing (OUT) them in
LD 11. This is because the Voice Services card does not receive any messages
from the Meridian 1 on a move or an out command. This can lead to Voice
Services ports being left in an indeterminate state, as the Voice Services card
receives no indication that the port has been moved or outed.

Perform this procedure only if the Voice Services card is not functioning
properly or if calls are not routed as intended. You may cause problems if you
stop and start the Voice Services card.
Log on to the M1, M1 IE, or Succession CSE 1000.
Load Overlay 32 by typing LD 32 at the prompt.
Never configure more ports on a Voice Services card than the
keycode or DSP infrastructure allow (whichever is lower). The
extra ports will not be usable for Voice Services.
Important: The base card DSP capacity is 8 ports. Each additional
DSP module adds another 8 ports, up to a maximum of 24 ports.
The number of ports enabled by the keycode appears on the
faceplate by K:XX, where XX is the number of enabled ports.