Annex - Bay Networks 6300 Supplement Manual

Book C
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
Table C-2. The na Commands (continued)
Command Description
reset Resets an internal port, interface, or subsystem.
set Defines or modifies the value of a parameter.
show Displays the current value of a parameter.
write Writes the current configuration to a script file.
After installing na on a UNIX host, type na at a terminal connected to
this host. No arguments or command line options are available.
% na
Annex network administrator Rx.x
command:
Seven of the na commands use standard UNIX superuser protection –
only a superuser at the host can execute these commands: boot,
broadcast, copy, dumpboot, read, reset, and set.

annex

The annex command establishes a default annex_list that is used in
subsequent commands. Before issuing an na command, specify the
RA 6300 to which the executed command refers. The RA 6300s you
specify using the annex command become the default annex_list. You
can group several RA 6300s into a single list, and then issue one
command for the entire group of RA 6300s. The syntax is:
annex annex_list
Chapter 1 na Commands
C-5