Bay Networks 6300 Supplement Manual page 80

Supplement to the remote annex administrator’s guide for unix

Hide thumbs Also See for 6300:

Table of Contents

Conﬁguring the PRI Interface, Global Ports, and Sessions

Conﬁguring the PRI Interface

Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX

Once you have ordered your PRI line from the telephone company and

have installed the 6300 hardware and software, you are ready to set

generic parameters for the PRI interface. The following superuser CLI

admin command displays these parameters and their default values:

annex# admin

ANNEX-PRI Rx.x, 24 async, 32 sync, 32 ta, 24 modem ports

admin: show pri

PRI Generic Parameters

switch_type: ""

dsx1_line_length: 0-25

fdl_type: att

To reset their default values, execute the admin command or the host-

based na utility, using the following syntax:

set pri parameter value

describes the parameters.

The following example uses admin to reset the switch_type parameter:

admin: set pri switch_type dms

num_b_channels: 0

buildout: 0dB

analog_encoding: auto