Ppp_Mru; Ppp_Ncp; Ppp_Password_Remote - Bay Networks 6300 Supplement Manual

Chapter 2 Configuration Parameters Book C

ppp_mru

This asynchronous/synchronous port parameter defines the maximum
receive unit (MRU) that the RA 6300 requests as its local MRU. If NAKed
and the remote hint is less than this value, the RA 6300 accepts the hint;
otherwise, the RA 6300 requests the PPP default (1500). Values range
from 64 to 1500. The default is 1500.

ppp_ncp

This asynchronous/synchronous port parameter specifies the network
control protocols that run on the interface. The RA 6300 negotiates for
these protocols only. Valid settings are one or more of the following: ipcp
(Internet Protocol Control Protocol), atcp (AppleTalk Control Protocol),
ipxcp (Internet Packet Exchange Control Protocol), mp (Multilink PPP),
and ccp (Compression Control Protocol). Separate multiple protocols
with commas. You can also specify all to indicate all of the protocols,
which is the default.
For information on Multilink PPP, see the Multilink PPP Addendum to
the Remote Annex Administrator's Guide for UNIX.

ppp_password_remote

This asynchronous/synchronous port parameter defines a PPP port user's
password. The string size ranges from 0 to 16 characters. For security
reasons, the RA 6300 displays this parameter's value as "<set>" or
"<unset>." The default is "<unset>."
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
C-86