Bay Networks 6300 Supplement Manual page 127

Book A
Remote Annex 6300 Supplement to the Remote Annex Administrator's Guide for UNIX
2. Use the set pri b command with the remote_address global port
parameter to associate a set of IP addresses with the PRI B
channels.
Step 2 is optional since the RA 6300 ignores the IP
address/B channel assignments created using the set pri
b command when it uses dial-up addressing. However, if
the host where the ACP server resides is unreachable by
the RA 6300, or there is no entry in the acp_dialup file
for a particular user, the RA 6300 relies on the IP
addresses assigned to the B channel to provide a remote
address for the link.
3. Edit the Annex configuration file to define an SPB.
You can use the default SPBs provided as part of the Annex
configuration file or create them specifically for your requirements.
For more details, see
page 6-91.
4. Reset the default global port parameters as required to the
following settings:
• Enable CLI and/or connection security using the security
parameters: cli_security and connect_security.
• The slip_ppp_security parameter controls dial-in PPP
access and use of ACP for PPP and protocol security such as
pap, chap and chap-pap. If enable_security and
slip_ppp_security are enabled, access to the PPP command
is restricted via ACP and call access is logged in the ACP log
file.
• Set the ppp_security_protocol parameter to pap, chap,
chap-pap, or, for CLI users (in some instances), none.
• Set the ppp_username_remote and
ppp_password_remote parameters to the values expected
by the remote node (the PC in
Chapter 6 Point-to-Point Protocol (PPP)
Step 2: Edit the Annex Configuration File
Figure A-5).
on
A-99