Installing A Full Length Sata Dom - Nexcom NISE 3520 Series User Manual

Chapter 3: System Setup

Installing a Full Length SATA DOM

If you intend to install a full length SATA DOM, you may install
one SATA hard drive only.
1. Prior to installing the full length SATA DOM, remove any drive bay that
may have been previously installed.
2. Locate for the SATA connector on the board.
3. Align the SATA connector located on the solder side of the SATA DOM
to the SATA connector that is on the board and then press it down
firmly. Secure the SATA DOM with the provided mounting screw.
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
SATA DOM
Mounting screw
SATA connector
Solder side of
SATA DOM
4. Before installing the single drive bay back, you must first replace the 4
mounting studs.
Now place the single drive bay by aligning the mounting holes of the
drive bay with the mounting studs.
53
Mounting
hole
NISE 3520 Series User Manual