Testing The Norstar Voice Mail Software; Backing Up Norstar Voice Mail Programing After The Upgrade; Re-Installing Cintech Dial-By-Name; Re-Enabling The Monitor, Keyboard And Mouse - Nortel Voice Mail Software Manual

38 Upgrading a Norstar Voice Mail system with a 270 MB hard disk drive

Testing the Norstar Voice Mail software

After you have completed the upgrade you must test the Norstar Voice Mail 4.1
software to make sure it is functioning. Refer to
software" on page 38.

Backing up Norstar Voice Mail programing after the upgrade

For system security, perform a backup of the Norstar Voice Mail programing and
the capabilities file after completing the upgrade process. For more information on
backing up the Norstar Voice Mail programing and the capabilities file, refer to
"Backing up Norstar Voice Mail programing"
NAM capabilities file"

Re-installing Cintech Dial-by-Name

The methods used to upgrade the system software will may cause
Dial-by-Name (DBN) to fail to load after the system is rebooted. To re-install the
Dial-by-Name (DBN), refer to

Re-enabling the monitor, keyboard and mouse

If you have a monitor, keyboard and mouse attached to your system, you must re-
enable the monitor after the upgrade.
To enable the monitor, keyboard and mouse:
NEXT
ADD
Norstar Voice Mail 4.1 Software Upgrade Guide
on page 16.
"Updating Cintech Dial-by-Name"
1. Press Ä áÚÞ .
2. Enter the ACCESS password. The default password
is ACCESS2 (2223772).
3. Press
ADMIN
4. Press
5. Press
SHOW
6. Enter the default password
à¡ÝÛßÜÜÜÜÜ
(SVGANEEDED).
7. Press
"Testing the Norstar Voice Mail
on page 15 and
.
until the display shows
.
.
"Backing up the
on page 23.
.
P0994576 Issue 01