Table of Contents
Advertisement
T
UTORIAL
59. Select the Password Box by [clicking] it. Enter CHAPPC in the Password
Box.
60. [Click] the down-arrow on the right hand side of the Address Assignment
Box. The options revealed are DontCare, NASSelects and Specific.
Select "NASSelects".
61. Leave the Address Box blank.
62. [Click] the down-arrow on the right hand side of the CLI Box. The
options revealed are Ignored, ExactMatch and PartialMatch. Select
"Ignored".
In this tutorial example it is assumed that number of the line used by the
roving PC User will continually change. Therefore there is no point in
checking the CLI of the remote end of the line each time the roving Account
User dials in.
63. Leave the CLI (Tel) Box Blank.
64. [Click] the down-arrow on the right hand side of the Path Type Box. The
options revealed are PPP, Nautica and Undistinguished. Select PPP for
this Account User (as it is a PC using an Integral TA and a PPP stack).
65. [Click] the Edit Button to the right of the Path Type Box. This will reveal
the "Multi-link PPP Path" window.
66. Leave the Bridge Unrouted Data Box blank
67. The Bridge Unrouted Data should never be selected on PPP Paths, as there
is currently no support for BCP (Bridging) on PPP Paths.
68. Select the Max. Multi-link ports Box and enter the maximum number of
ISDN B-Channels that this Account User is allowed to use while
connecting to the NAS Router. Enter 1 in the Max. Multi-link ports Box.
69. Next set the Outgoing Call Parameters. For this tutorial example leave the
Demand Threshold at 0 (%), the Idle Threshold at 0 (%) and the Threshold
Period at 10 seconds, i.e. their Default values.
3-28
Advertisement
Table of Contents
