Table of Contents
Advertisement
T
UTORIAL
The "Configure Paths Menu" should now be exactly the same as that shown
be at the top of the next page.
30. Type CO IP<CR> at the Command Line prompt. The "Configure IP
Routes Menu" should now be displayed with the IP Route with Id equal
to 1 highlighted.
31. Type AD S<CR> at the Command Line prompt. The "Update IP Route
Form" should now be displayed.
32. Change the IP Address parameter from "0.0.0.0" to 10.0.0.2/32.
A Static IP Route has now been configured. The CLAM will now only allow
calls to be made when connections to the UNIX Host (i.e. 10.0.0.2) are
requested. No other outgoing calls should be attempted to any other IP
Address.
33. Change the Path parameter from "LAN01" to HQ_MARLIN.
34. Submit the changes by pressing Control E. The Main Menu should now
be displayed. The message "Please use the Save command" will also
appear in the middle of the fifth line up from the bottom of the screen.
3-54
Advertisement
Table of Contents
