Table of Contents
Advertisement
T
UTORIAL
As can be seen from "Configure Paths Menu" above the only Path
(destination) the Marlin Router knows about is its local LAN (LAN01). This
is because the RADIUS Server creates and deletes the relevant remote
Account User path information as and when a connection is requested to or
from (as is configured in the Account User profile) the remote Account User.
This implies that the number of Paths displayed on the "Configure Paths
Menu" will vary depending on who has gained access to the Network via the
RADIUS Server.
25. Type CO RA<CR> at the Command Line prompt. The "RADIUS
Configuration Parameters" form should now be displayed.
26. Change the Security Server IP Address from "0.0.0.0" to 10.0.0.3.
27. Change the Security Server Password from "null" to PASSWORD. This
must match the entry in Authentication Box of the NAS Name window in
the appropriate NAS unit.
28. Change the Security Server Service Quality parameter from "NO" to
"YES".
29. Change the Accounts Server IP Address from "0.0.0.0" to 10.0.0.3.
30. Change the Accounts Server Password from "null" to PASSWORD. This
must match the entry in Authentication Box of the NAS Name window in
the appropriate NAS unit.
31. Change the Access Server Session Logging parameter from "NO" to
"YES"
32. Change NAS Clustering Master NAS IP address FROM "0.0.0.0" from
10.0.0.1.
33. Change NAS Clustering (IPX Node) address from "000000000000" to the
Marlin's MAC address (which can be found by looking at the LAN01
Update Path Form).
34. Change the Dynamic IP Allocation Pool Start address to "0.0.0.0" from
10.10.0.1.
35. Change the Dynamic IP Allocation Pool Length parameter from "0" to 30.
3-40
Advertisement
Table of Contents
