Table of Contents
Advertisement
45. Type CO IPXR<CR> at the Command Line prompt. The "Configure IPX
Routes Menu" should now be displayed with the IP Route with Id equal to
1 highlighted.
46. Type AD S<CR> at the Command Line prompt. The "Update IPX Route
Form" should now be displayed.
47. Change the Net parameter from "00000000" to 00DADD1E.
48. Change the Hops parameter from "1" to 14.
49. Change the Ticks parameter from "1" to 14.
50. Change the Path parameter from "LAN01" to "VirtualPath".
A Static IPX Route to the RADIUS Server has now been configured. The
operation described above for IP packets is now repeated but IPX Network
Address' are used instead of IP Address'.
51. Submit the changes by pressing Control E. The Main Menu should now
be displayed. The message "Please use the Save command" will also
appear in the middle of the fifth line up from the bottom of the screen.
52. Type SAVE<CR> at the Command Line prompt. The word SAVE will
disappear after a few seconds and the message "Please use the save
command" will also disappear.
T
UTORIAL
3-43
Advertisement
Table of Contents
