Table of Contents
Advertisement
T
UTORIAL
16. Submit the changes by pressing Control E (i.e. the "Ctrl" Key and the E
Key together). The Main Menu should now be displayed. The message
"Please use the Save command" will also appear in the middle of the fifth
line up from the bottom of the screen.
17. Type SAVE<CR> at the Command Line prompt. The word SAVE will
disappear after a few seconds and the message "Please use the save
command" will also disappear.
18. Type CO PA<CR> at the Command Line prompt. The "Configure Paths
Menu" should now be displayed with the LAN01 Path highlighted.
19. Type ED<CR> at the Command Line prompt. The "Update Path Form"
should now be displayed.
20. Change the IPAddr&Mask parameter from "1.1.1.1" to 10.0.0.1/8
21. Set the IPX Mode to "802.3.
22. Change the IPX Network 8023 parameter from the default of "00000000"
to 00B0BB1E.
The "Update Path Form" should now be exactly the same as that shown at the
top of the next page.
3-38
Advertisement
Table of Contents
