Table of Contents
Advertisement
25. Add the ISDN number(s) allocated to the PRI line connected to the
Marlin at HQ. For this tutorial enter the number 01712469753 to the
ISDN01 parameter field.
26. Change the SecureKey (EncrypionKey on V1 and V2) parameter from
"0" to 123.
27. Change the AllowRIP parameter from "RIP1Compat" to "None".
The "Update Path Form" should now be exactly the same as that shown
below.
As can be seen from "Configure Paths Menu" above the only Paths
(destinations) the CLAM Router knows about is its local LAN (LAN01), and
the Marlin located on the HQ Backbone Network (HQ_MARLIN).
28. Submit the changes by pressing Control E. The Main Menu should now
be displayed. The message "Please use the Save command" will also
appear in the middle of the fifth line up from the bottom of the screen.
29. Type SAVE<CR> at the Command Line prompt. The word SAVE will
disappear after a few seconds and the message "Please use the save
command" will also disappear.
T
UTORIAL
3-53
Advertisement
Table of Contents
