Scheduling A Test Conference; Defining General Attributes - Nortel ICB Administrator's Manual

30 Browser User Interface
6 The Automatic Daylight Saving Time option selected, specifies
7 Do one of the following:

Scheduling a test conference

1 After the Wizard setup session is complete, schedule a conference
2 If necessary, return to the ICB Professional Install Wizard to

Defining general attributes

Follow the procedures below to define general conference settings.
1 Click Define General attributes in the Console.
Standard 01.01 June 2007
a Clicking in the Update Time box, uses to set the current time on
installation or to correct the time when needed to move manually
to daylight saving time.
b In the Daylight Bias field, specify the difference between DST
and standard time (one hour in most countries).
c In the Time Zone field, specify the local time zone of local
Standard Time (offset from GMT). Time zone is displayed in the
Web Browser scheduling screens and in the scheduling
confirmation e-mails.
d In the IP address of Network Time Server field, optional feature
- keeping time synchronized with a network time servers by NTP
protocol. The system uses it only for synchronizing hour
boundaries; it will not change date or hour by NTS server.
Therefore, date and time must be set initially even if this option is
used.
here if ICB Professional should pass automatically to daylight saving
time. This is useful in countries where the dates are fixed. The "Start
Day" and "End Day" shell be set as used in the local country.
a Click Back to return to the previous step without saving the
changes.
b Click Finish to save the changes and return to the Console.
c Click Console in the title frame to return to the Console without
saving the changes.
and place a call to test the system.
change system definitions.
Refer to Nortel Integrated Conference Bridge Professional User
Guide for instructions on scheduling a conference.