Installing The Ground Wire - Paradyne 5011 Installation Instructions Manual

Installing the Ground Wire

8
3. Use a Phillips screwdriver to install the:
— Single-card chassis in 19 or 23 rack, or a six-card chassis in a
19 rack.
— Six-card chassis in a 23 rack. Install the top two screws loosely enough
to allow the bracket's upper keyholes to drop under the screw heads
during installation.
4. Line up the chassis-mounting bracket with the speed nut and start to rotate
the speed nut screw into the chassis mounting bracket and the speed nut.
5. Loosely install the bottom screws first and then the top screws. Tighten each
screw until the head is flush with the chassis and securely mounted in the
rack.
To install the next chassis in the same manner, follow Steps 1 through 5. For a
standard rack installation, chassis can be mounted directly on top of each other.
To comply with National Equipment Building Standards (NEBS) requirements, the
ground wire must be installed.
Procedure
1. There is a ground lug on each chassis. Locate the ground lug.
If you have a . . .
Single-card chassis
Six-card chassis
CO POTS Splitter
Single-Card Chassis
March 1998
Then the ground lug is . . .
On the rear of the chassis on the left.
On the front of the chassis on the top right.
98-15876
5020-A2-GN10-20