Advertisement
Quick Links
HotWire 5034 Indoor POTS Splitter Customer
Premises
Installation Instructions
Document Number 5034-A2-GN10-10
October 1997
Before You Begin
Verify that:
The local loop POTS service is
connected to the POTS/DSL network.
New or existing unshielded
twisted-pair wiring (CAT3 or better)
is used from the DSL jack to the
POTS splitter and from the POTS
splitter to the RTU. The CAT3
wiring must meet EIA/TIA-568
specifications with 24 AWG (.5 mm)
or 26 AWG (.4 mm).
Three cables are available that meet the CAT3 wiring specifications with RJ11
connectors at both ends. Refer to
Your package contains a POTS Splitter and a Warranty Card.
For RADSL (Rate Adaptive Digital Subscriber Line) RTU installation information, refer to
the appropriate RTU document:
Document Number
5216-A2-GN10
5246-A2-GN10
5446-A2-GN10
TM
5034 Indoor POTS Splitter
Installing the 5034 POTS Splitter
Document Title
HotWire 5216 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
HotWire 5246 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
HotWire 5446 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
1
, page 3.
Advertisement
Related Manuals for Paradyne HotWire 5034
Summary of Contents for Paradyne HotWire 5034
- Page 1 HotWire 5034 Indoor POTS Splitter Customer Premises Installation Instructions Document Number 5034-A2-GN10-10 October 1997 Before You Begin Verify that: The local loop POTS service is connected to the POTS/DSL network. New or existing unshielded twisted-pair wiring (CAT3 or better) is used from the DSL jack to the POTS splitter and from the POTS splitter to the RTU.
- Page 2 What Does the POTS Splitter Do? The POTS splitter and HotWire Remote Termination Unit (RTU) are components in the RADSL Access System. This system provides high-speed Internet or corporate LAN access over traditional twisted-pair copper telephone wiring. The POTS splitter filters out the DSL signal and allows the POTS frequencies to pass through.
- Page 3 Installing the 5034 POTS Splitter The POTS splitter is made for tabletop placement and uses three cables with RJ11 connectors. The three cables are used: From the Local Loop to the POTS splitter From the POTS splitter to the telephone...
- Page 4 5034 Indoor POTS Splitter Technical Specifications Item Specification Width x Depth x Height 3.63 x 5.78 x 1.52 (9.22 cm x 14.68 cm x 3.86 cm) Weight 6.7 ounces (190.0 grams) Safety Certifications Refer to the equipment’s label for approvals on product.
-
Page 5: Important Safety Instructions
Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual. 2. This product is intended to be connected to Listed/Certified telephone wiring with a minimum of 26 AWG (.4 mm) behind a Listed/Certified primary protector. 3. - Page 6 RENs, contact the local telephone company. If the Model 5034 Telephone Line Filter causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required.