Table of Contents
Advertisement
Installation of the Cable Heads
5020-A2-GN10-20
This section provides instructions to make the necessary cable connections to
the POTS splitter. Each cable can have a right-angle or left-angle exit from the
connector, depending on the wiring requirements.
The POTS splitter card has three interfaces:
Use interface connector labeled . . .
DSL Interface
LOOP Interface
PSTN Interface
Procedure
1. Determine how the cables will be dressed. The cables can be dressed from
either side based on the cable heads. Each cable head can have left-angle or
right-angle heads.
2. Feed the cable head through the chassis' front right or left opening.
3. Install the plastic tie-wrap anchor onto the faceplate on the cable exit side
with the screws provided.
4. Slide the tie wrap through the anchor from the top.
March 1998
To connect to the . . .
DSL interface on the 8800 or 8600 chassis.
Local loop via MDF or distribution frame.
PSTN switch.
15
Advertisement
Table of Contents
