Table of Contents
Advertisement
16
5. Attach the cable head to the POTS splitter connector.
— If the connector on the cable has a long screw, tighten the screw directly
into the connector located in the circuit card. Discard the jack screws
provided.
— If the connector on the cable has a short screw, install the #4-40 jack
screw provided into the threaded hole of the connector in the circuit card.
Attach the short screw in the cable to the jack screw and tighten.
6. Tighten the tie wrap and trim the excess.
Repeat the procedure for all the interface cables.
March 1998
5020-A2-GN10-20
Advertisement
Table of Contents
