Table of Contents
Advertisement
5020-A2-GN10-20
CO POTS Splitter
Six-Card Chassis
2. Strip back the insulation approximately 1/4 to 3/8 on the copper wire.
If you have a . . .
Single-card 5011 chassis
Six-slot 5016 chassis
3. Loosen the screw on the GND lug.
4. Insert the stripped end of the wire into the open end of the GND lug and
tighten the lug's screw. Make sure that the wire is making contact with the
stripped portion of the wire.
March 1998
Then the ground wire gauge must be . . .
10 — 14 AWG.
6 — 14 AWG.
98-15879
98-15877
9
Advertisement
Table of Contents
