Table of Contents
Advertisement
POTS Splitter Chassis Installation
Planning the POTS Splitter Chassis Installation
5020-A2-GN10-20
The following figure provides an example of two POTS splitter chassis center
mounted in a 19 rack with two 8800 DSLAMs in a 19 cabinet.
19" Cabinet
POWER
ALARMS
A
B
Fan
Major Minor
8800
DSLAM
Chassis
A
B
POWER
ALARMS
A
B
Fan
Major Minor
A
B
The POTS splitter chassis is shipped with mounting brackets to allow installation
in a rack that is either 19 or 23 wide. To plan the bracket and chassis
installation, determine:
Width of the rack: 19 or 23 .
Chassis position in the rack: center mounted or front mounted. Center
mounted is recommended for convenient access to cables.
Whether the rack has mounting rails with threaded or non-threaded screw
holes.
If a single-card 8600 DSLAM chassis is being placed on a table top. If so,
plan to install the
rubber feet
any rack-mounted chassis.
NOTE:
In order to reduce the risk of accidental tip over, it is strongly recommended
that the chassis be installed into the rack from the bottom up.
March 1998
19" Rack
Six-Card
POTS
Splitter
Chassis
as shown on page 2. Discard rubber feet for
97-15426a-01
5
Advertisement
Table of Contents
