Table of Contents
Advertisement
| Main Controller: 5x16 Segment Programmable
Chapter 6
|
6-42
305435H03
SCROLL
button through parameters in Level 2 and set the required End.T by
pressing UP
or DOWN
OR
To Configure the Programmer
1. Enter Level 2: refer to section "To Enter Level 2" for steps to enter Level 2.
2. To select the Programmer, press SCROLL
to view 'PROG'.
3. To configure the first Program, press DOWN
program number '1'.
Similarly you can configure program (1, 2, 3, 4 or 5) for configuration.
4. To set the ramp unit, press SCROLL
press DOWN
or UP
example the ramp unit is set in min).
5. To set the Dwell unit, press SCROLL
DOWN
or UP
unit is set in min).
6. To set the first Target Set point, press SCROLL
DOWN
or UP
button.
OR
button as many times as necessary
or UP
button to select 'RAMP.U' and then
button to select hour, min or sec (In this
button to select 'DWEL.U' and then press
button to select hour or min (In this example the dwell
button to set the value.
button to select
button to select 'TSP.1'. Press
1500°C Tube Furnace
Advertisement
Table of Contents
