Nortel CallPilot Mini Reference Manual page 55

To change the destination from telephone or extension to pager
1 Dial the CallPilot Messaging access number, then enter your mailbox number and press
2 Enter your mailbox password and press
3 Press to open the Message Notification menu.
¡ Þ Û
4 Press to change Message Notification.
Ú
5 Press to change the destination type and the destination number.
Ú
6 Press to choose a pager number destination.
Ü
7 Enter the pager number and press
8 Press to accept the destination pager number, or
£
• press to cancel and reenter the number
¥
• press to add special characters and use your dialpad or follow the voice prompts to add
Û
characters. After you add special characters, press
For more information about special characters, refer to
destination number" on page
9
Press to accept the default pager message. The default pager message that CallPilot sends
£
is the CallPilot extension. This is the sequence of digits that is sent after the pager service is
dialed, to notify you of who is paging you
or
press to change the pager message.
Ú
The combined limit is 30 characters for the pager telephone number and the pager message.
10 Press
to continue.
£
11 Press
if you want to set up another destination
Ú
or
press if you do not want to set up another destination.
£
12 Press if you want to be notified when you receive a new message
£
or
press if you want to be notified only when you receive an urgent message.
Ú
13 Hang up to end the session.
.
£
to continue.
£
£
38.
Chapter 7 Message Notification
to accept the destination number.
"Adding special characters to a
CallPilot Mini Reference Guide
55
.
£