Changing Remote Message Notification - Nortel CallPilot Mini Reference Manual

52 Chapter 7 Message Notification

Changing Remote Message Notification

You can change the parameters and destinations for Message Notification. Refer to
Notification parameters" on page 44
If you want to change the time or message type parameters, use the procedure
range or type of message parameters" on page 52
If you want to change the destination type refer to the procedure for the destination type.
To change the destination type
from a telephone to an extension, pager or another telephone
number
from a pager to an extension or telephone
from a telephone or extension to a pager
To change the time range or type of message parameters
1
Dial the CallPilot Messaging access number, then enter your mailbox number and press
2
Enter your mailbox password and press
3
Press
¡ Þ Û
4
Press to set up Message Notification.
Ú
5
Press to continue until the prompt announces the start time.
£
If you want to change the destination type refer to
for the appropriate procedure.
6 Press to change the start time
Ú
or
press to accept the start time.
£
7 Press to change the stop time
Ú
or
press to accept the stop time.
£
8 Press to change the message type
Ú
or
press to accept the message type. You can choose to be notified of all new messages or
£
urgent messages only.
Change the message type to urgent to be notified only when you receive an urgent message.
9
Hang up to end the session.
P0989496 03
for more information about parameters.
to open the Message Notification menu.
refer to
page 53
page 54
page 55
.
£
"To change the destination type" on page 52
"Message
"To change the time
.
£