Access The Icb Directly - Option 11C Or Cs 1000; Nortel Integrated Conference Bridge: Service Implementation Fundamentals; Nn43001-558/555-4001-135 01.02 Standard - Nortel 2100 Fundamentals

70 Installation and configuration
If installing the ICB card in an Option 11C or CS 1000, use the following
procedures to connect the Maintenance terminal.
In the procedures that follow, the connections are the same for the Option
11C and the CS 1000, the only difference is that the connectors are on the
back of the Call Server and Media Gateway for the CS 1000, whereas they
are on the bottom of the Option 11C cabinet.
Table 13 "DB-9 RS-232 port pin out" (page 70)
assignment that the next two procedures use.
Table 13
DB-9 RS-232 port pin out
9-pin (male) serial connector pin #
2
3
5
Procedure 8

Access the ICB directly - Option 11C or CS 1000

Step
1
2
3
Nortel Communication Server 1000/Communication Server 2100 Solution/Meridian SL-100

Nortel Integrated Conference Bridge: Service Implementation Fundamentals

Copyright © 2007, Nortel Networks
.
Note: These procedures do not apply to the Meridian 1 Options 51C,
61C or 81C or the CS 2100/Meridian SL-100.
Action
Position the Maintenance terminal on a desk near the system.
If the system is an Option 11C perform the following:
a. Verify that the Ethernet Adapter is installed in the Option 11C.
b. Plug the terminal cable DB-9 female connector into the DB-9
male connector on the Ethernet Adapter on the I/O panel.
c. Plug the DB-25 male connector at the other end of the terminal
cable into the RS-232 connector on the terminal. If the
connection requires a gender changer, obtain one at a local
electronics store.
If your system is a CS 1000, connect the NTBK48 three-port SDI
cable to the 9-pin SDI connection (COM RS-232) at the back of the
Call Server and Media Gateway.

NN43001-558/555-4001-135 01.02 Standard

ICB Release 4 20 June 2007
—End—
describes the DB-9 pin
Signal Description
RS-232 TX (transmit)
RS-232 RX (receive)
GND