Table 9 Configuring Ospf Over A Secondary Address - Nortel Contivity 1100 Configuration Manual

Table 9 displays the command syntax for configuring OSPF.

Table 9 Configuring OSPF over a secondary address

Command description
Enable OSPF on a secondary address
Disable OSPF on a secondary address CES(config-if)# no ip ospf <secondary
Set the OSPF authentication key
Reset the OSPF authentication key
Set the OSPF cost on a secondary
address
Reset the OSPF cost on a secondary
address
Set the OSPF dead interval on a
secondary address
Reset the OSPF dead interval on a
secondary address
Set the OSPF hello interval on a
secondary address
Reset the OSPF hello interval on a
secondary address
Set the OSPF retransmit interval on a
secondary address
Reset the OSPF retransmit interval on a
secondary address
Set the OSPF transmit delay on a
secondary address
Reset the OSPF transmit delay on a
secondary address
Set the OSPF network on a secondary
address to be a point-to-point or a
broadcast network
Disable OSPF network on a secondary
address
Set the OSPF polling interval on a
secondary address
Reset the OSPF polling interval on a
secondary address
Chapter 5 Configuring the system 101
Command syntax
CES(config-if)# ip ospf <secondary address>
address>
CES(config-if)# ip ospf authentication-key
<auth-key> <secondary address>
CES(config-if)# no ip ospf authentication-key
<secondary address>
CES(config-if)# ip ospf cost <1-65535>
<secondary address>
CES(config-if)# no ip ospf cost <secondary
address>
CES(config-if)# ip ospf dead-interval <1-65535>
<secondary address>
CES(config-if)# no ip ospf dead-interval
<secondary address>
CES(config-if)# ip ospf hello-interval <1-65535>
<secondary address>
CES(config-if)# no ip ospf hello-interval
<secondary address>
CES(config-if)# ip ospf retransmit-interval
<1-3600> <secondary address>
CES(config-if)# no ip ospf retransmit-interval
<secondary address>
CES(config-if)# ip ospf transmit-delay <1-3600>
<secondary address>
CES(config-if)# no ip ospf transmit-delay
<secondary address>
CES(config-if)# ip ospf network <broadcast/
point-to-point> <secondary address>
CES(config-if)# no ip ospf network <secondary
address>
CES(config-if)# ip ospf poll-interval <1-65535>
<secondary address>
CES(config-if)# no ip ospf poll-interval
<secondary address>
Nortel VPN Router Configuration — Basic Features