Accessing Acl Through The Gui; Configuring The Serial Interface - Nortel Contivity 1100 Configuration Manual

To set an ACL for TELNET, enter the following NNCLI command:
CES(config)#telnet access-list <the_name_of_an_acl>
To remove an ACL for TELNET, enter the following command:
CES(config)#no telnet access-list

Accessing ACL through the GUI:

To access ACLs from the GUI:
1
2
3

Configuring the serial interface

The Serial Interface allows you to configure the IP address and subnet mask so
that you can then use a Web browser for management.
Your terminal emulator must use the following communications parameters:
•
•
•
•
•
The Serial Interface configuration procedure is typically only necessary in a
system recovery situation.
1
2
Select Services > Available. The Allowed Services window appears.
Select one of the predefined ACLs.
Click OK.
9600 baud
8 data bits
1 stop bit
No parity
No flow control
Connect the serial cable (supplied with your Nortel VPN Router) from the
Nortel VPN Router serial port to a terminal or a communications port of a PC.
Power on the terminal or PC.
Nortel VPN Router Configuration — Basic Features
Chapter 2 Getting started 45