Nortel 222 User Manual page 293

Table 73 IPSec commands
Command
btNatType
btNatAddrStart
btNatArEnd
swSkipOverlapIP <on|off>
adjTcpMss <off|auto|user
defined value>
contivityDial
contivityDrop
contivityState
contivitySplit
contivityTimecnt <0~65535>
exemptHost
display
load <index>
active <Yes|No>
sourceStart
sourceEnd
destStart
destEnd
save
btNatList
<0:single |
1:range |
2:all>
<IP address>
<IP address>
<IP address>
<IP address>
Nortel Business Secure Router 222 Configuration — Advanced
Appendix H Command Interpreter 293
Description
Sets the type of NAT address mapping.
Sets the branch tunnel NAT starting IP
address.
Sets the branch tunnel NAT ending IP
address or subnet mask.
Turn this option on to have the device
allow rules with overlapping source and
destination IP addresses.
Sets the adjust TCP Maximum Segment
Size.
Initiates the Contivity Client VPN
connection.
Ends the Contivity Client VPN
connection.
Displays information about the Contivity
Client VPN connection.
Sets the Contivity Client keep-alive
interval (in seconds).
Uses the exemptHost commands to
configure specific IP addresses that are
not to be part of a VPN tunnel.
Displays the exempt host settings.
Loads an exempt host.
Enables or disables an exempt host.
Sets the exempt host's source start IP
address.
Sets the exempt host's source end IP
address.
Sets the exempt host's destination start
IP address.
Sets the exempt host's destination end IP
address.
Saves an exempt host.
Displays the branch tunnel NAT entries.