CAUTION
DANGER
WARNING
CAUTION
CAUTION
28 of 56
Installation and operating manual
5.4.1.4 Motor temperature
Insufficient cooling
Damage to the pump (set)!
Never operate a pump (set) without operational temperature monitoring.
The thermal motor protection device stops the pump if the maximum
permissible motor temperature is reached and re-starts it automatically after
the motor has cooled down. The pump's power supply must be protected by a
circuit breaker set to the rated motor current or a 10A fuse.
5.4.2 Electrical connection
Electrical connection work by unqualified personnel
Risk of fatal injury due to electric shock!
Always have the electrical connections installed by a trained and qualified
electrician.
Observe the IEC 60364 regulations as well as any regional regulations.
Incorrect connection to the mains
Damage to the mains network, short circuit!
Observe the technical specifications of the local energy supply companies.
Inspect the power cable for visible damage.
Never connect damaged power cables.
Improper routing of power cable
Damage to the power cables!
Never move the power cables at temperatures below - 25 °C.
Never kink or crush the power cables.
Never lift the pump set by the power cables.
Adjust the length of the power cable to the site requirements.
Motor overload
Damage to the motor!
Protect the motor by a thermal time-lag overload protection device in accordance
with IEC 60947 and local regulations.
Delta Foul V3 Submersible Pump