Delta Foul V3 Installation And Operating Manual page 29

For electrical connection observe the wiring diagrams and the information for
planning the control system (
The pump set is supplied with a connection cable. Always connect all marked cores.
DANGER
DANGER
CAUTION
1. Run the power cables directly upwards without slack, and fasten.
2. If necessary, adjust the length of the power cables to the site requirements.
3. After shortening the cables, correctly re-affix the markings of the individual
cores at the cable ends.
DANGER
Delta Foul V3 Submersible Pump
Section 9.3, Page 51).
 
Operating a pump set that has not been fully connected
Explosion hazard!
Damage to the pump set!
 Never start up a pump set with power cables that have not been fully connected or
non-operational monitoring devices.
Connection of damaged power cables
Danger of death from electric shock!
 Check the power cables for damage before connecting them.
 Never connect damaged power cables.
 Replace damaged power cables.
Flow-induced motion
Damage to the power cable!
 Run the power cable upwards without slack.
Figure 12. Fastening the power cables
Touching the pump set during operation
Electric shock!
 Make sure that the pump set cannot be touched during operation.
Installation and operating manual 29 of 56