Personnel Qualification And Training; Consequences And Risks Caused By Non-Compliance With This Manual - Delta Foul V3 Installation And Operating Manual

NOTE
2.3.1 Prevention of foreseeable misuse
• Observe the minimum flow velocities required to fully open the swing
check valves to prevent the reduction of pressure and risk of clogging.
(Contact the manufacturer for the required minimum flow velocities/loss
coefficients.)
• Never open the discharge-side shut-off elements further than permitted.
– The maximum flow rates specified in the product literature or data sheet
would be exceeded.
– Risk of cavitation damage
• Never exceed the permissible operating limits specified in the data sheet or
product literature regarding pressure, temperature, etc.
• Observe all safety information and instructions in this manual.

2.4 Personnel qualification and training

All personnel involved must be fully qualified to transport, install, operate,
maintain and inspect the machinery this manual refers to.
The responsibilities, competence and supervision of all personnel involved in
transport, installation, operation, maintenance and inspection must be clearly
defined by the operator.
Deficits in knowledge must be rectified by means of training and instruction
provided by sufficiently trained specialist personnel. If required, the operator can
commission the manufacturer/supplier to train the personnel.
Training on the pump (set) must always be supervised by technical specialist
personnel.
2.5 Consequences and risks caused by non-compliance with this
manual
• Non-compliance with these operating instructions will lead to forfeiture of
warranty cover and of any and all rights to claims for damages.
• Non-compliance can, for example, have the following consequences:
– Hazards to persons due to electrical, thermal, mechanical and chemical
effects and explosions
– Failure of important product functions
– Failure of prescribed maintenance and servicing practices
– Hazard to the environment due to leakage of hazardous substances
Delta Foul V3 Submersible Pump
Free-flow impeller (impeller type F)
Suitable for fluids containing solids and stringy material
as well as fluids with entrapped air or entrapped gas.
2 Safety
Installation and operating manual 11 of 56