Using A Forklift; Hanging Unit From Ceiling (Horizontal Units) - Daikin PreciseLine Series Installation And Maintenance Manual

Using a Forklift

When using a forklift to transport units, make sure that forklift
tongs enter from the ends of the pallet, not the sides. In cases
where one end is heavier, enter the pallet from the heavier side
(e.g. for vertical units with a mixing box, enter from the side
opposite the mixing box).
NOTICE
The unit is shipped in a protective plastic coating with cardboard supports.
Plastic and cardboard will need to be removed before installation.
www.DaikinApplied.com
Hanging Unit from Ceiling
(Horizontal Units)
Do not suspend the unit from the top. The unit top will not support the weight
of the unit. Equipment damage and severe personal injury can result.
Before hanging, the unit should be rigged and completely
assembled. The PreciseLine air handler main section should
be positioned on the pallet to permit access to mounting
holes in the structural cross bracing under the unit. The entire
unit is then lifted on the pallet
minimum 1/2" threaded rod, washers and lock nuts through
all support bracing. If the pallet is not available, the fully
assembled unit may be supported by the main section, while
lifting into place (Figure 9 & Figure 10 on page 10).
case, the main section must be secured with the threaded rod
before the mixing box or discharge plenum. Spring isolation
is recommended on sizes 030, 040 and 050 as these units do
not have any internal vibration isolation. Refer to
Figure 14 on page 13.
To avoid damage to the unit cabinet, use spreader bars and non-abrasive
protective strips between straps and unit cabinet. to keep straps from
rubbing the frame, connections, or panels.
11 IM 1267-7 • PRECISELINE AIR HANDLER
Installation
WARNING
(Figure 12) and secured with
In this
Figure 15
CAUTION
and