Displaying Active Write Filters - Nortel Versalar 15000 Troubleshooting Manual

Managing and Troubleshooting the Versalar Switch Router 15000
Table 4-1.
-f
-s
Examples
log -i -fdft
log -i -fdi -s9
log -i -ff -eGAME
log -i -fd -s9 -eOSPF
log -i
log -x -fd
log -x
log -x -fdfitw

Displaying Active Write Filters

You can display a list of all write filters currently in effect across the router or for
a specific slot by entering the following commands:
log -z
log -z [-s <slot>
4-4
Log Command Options
Specifies the severity levels of messages that the
<severity_level>
router will log (write) to the local event log, or
exclude from the event log. The severity codes are:
•
•
•
•
•
(Debug events are for use and interpretation by
Nortel Networks Technical Solutions Center
personnel only.)
You can specify in the same
more severity codes.
Specifies the number of the slots for which the
<slot_number>
router will write event messages to the local log
buffer.
Includes only debug, fault, and trace events
Includes only debug and info events on slot 9
Includes only fault events for the router operating
system entity
Includes only debug events for OSPF running on
slot 9
Includes no events (none are specified)
Excludes only debug events
Excludes no events (none are specified)
Excludes all events (all severity levels are specified)
]
(continued)
f or F for fault
i or I for informational
t or T for trace
w or W for warning
d or D for debug
log
command one or
302768-C Rev 00