Nortel Versalar 15000 Troubleshooting Manual page 62

Managing and Troubleshooting the Versalar Switch Router 15000
rate
messages. The
value by entering a rate in seconds. The system displays the events that occur
between polling intervals.
code_no.
displays the events associated with the specified event code.
enables the
-w
Examples
log
log 9:ftp.log
log -d12/12/98
log -t09:02:00
log -eTFTP
log -eGAME -eIP
log -ffw
log -s10
log -eTFTP -ffw -s10
log -eTCP -eTELNET -ffw
log -p10
log -c8
log -w
4-6
enables continuous polling of the system's event log to display new event
option uses a default rate of 5 seconds. You can change this
-p
is an event code number or a range of event code numbers. The system
command to provide console output in wide format.
log
Displays all fault, warning, and info events in memory.
Displays all events saved to the ftp.log file stored on
volume 9.
Shows all events logged since December 12, 1998.
Shows all events logged since 9:02 today. If it is earlier
than 9:02, the console displays all events logged since
9:02 yesterday.
Displays all events logged by the TFTP service.
Displays all events logged by the GAME and IP
services.
Displays all fault and warning events.
Shows all events logged in slot 10.
Displays all fault and warning events logged by the
TFTP service in slot 3.
Displays all fault and warning events logged by the
TELNET and TCP services.
Shows all events logged in the past 10 seconds.
Shows all events associated with event code 8.
Displays all events in wide format.
302768-C Rev 00