Specifying The Alarm Logging Delay; Specifying The Alarm-Cleared Logging Delay - Nortel Versalar 15000 Troubleshooting Manual

Specifying the Alarm Logging Delay

By default, each T3, T1, or FT1 access interface waits 2 seconds before logging a
performance defect or anomaly as an event message.
To change the alarm delay value, go to the MCT3, T1, or FT1 prompt (for
example,
setup-alarm-threshold < delay >
delay
The following example shows how to change the alarm delay to 6 seconds on
slot 2, connector 1, FT1 channel 5:
ft1/2/1/5#
ft1/2/1/5#

Specifying the Alarm-Cleared Logging Delay

By default, each MCT3 and T3 port and each T1 and FT1 interface logs a
performance-cleared event message if a defect or anomaly resolves within 2
seconds.
To change the alarm clear delay, go to the MCT3, T1, or FT1 prompt and enter the
following command:
clear-alarm-threshold < delay >
delay
The following example shows how to change the clear alarm delay to 6 seconds on
T1 channel 4 on slot 2, connector 1:
t1/2/1/4#
t1/2/1/4#
302768-C Rev 00
,
mct3/2/1 t1/2/1/4
is an integer from 2 to 10 seconds.
setup-alarm-threshold 6
is any integer from 2 to 10 seconds.
clear-alarm-threshold 6
, or ), and enter the following command:
ft1/2/1/5
Monitoring and Troubleshooting
6-17