Configuring The System Core Image Dump; System Core Image Dump Navigation; Configuring The System Core Image Dump Using The Cli - Nortel 8300 Troubleshooting Manual

Variable
ports
Configuring the system core image dump
This section describes how to configure the system core image dump using
the CLI and the NNCLI.

System core image dump navigation

•
•
Configuring the system core image dump using the CLI
Use the following procedure to preserve a core image of RAM when the
system fails.
Prerequisites
•
•
Procedure steps
Step
1
2
Variable definitions
Variable
enable | disable
Copyright © 2007, Nortel Networks
.
"Configuring the system core image dump using the CLI" (page 155)
"Enabling the system core image dump using the NNCLI" (page 157)
The flash or the PCMCIA card must have enough free space to save a
core save compact file of more than 10 megabytes (MB).
The TFTP server must have write access for a core save normal file of
more than 100 MB .
Action
Configure the system core image dump by using the following
command:
config [diag] slot <slot#> core-save <enable|disable>
<file>
When a failure occurs, retrieve the file and call 1-800-4NORTEL
(1-800-466-7835).
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
Configuring the system core image dump
Value
Specifies the ports for which you are
entering the command in the form
portlist {slot/port[-slot/port][, ...]}.
—End—
Value
Enables or disables the system core image
dump. Disabled is the default.
155