Clearing Statistics Using The Cli - Nortel 8300 Troubleshooting Manual

Variable
<session id>
<vid>

Clearing statistics using the CLI

Use the following procedure to clear statistics from counters, flush entries
from a table, or end a Telnet session.
Procedure steps
Step
1
2
3
4
5
6
Variable definitions
Variable
[<ace-id>]
[<acl-id>]
<policy-id>
Copyright © 2007, Nortel Networks
.
Action
To clear specified filter statistics, enter the following command:
clear filter statistics [<acl-id>] [ace-id>]
To clear ARP VLAN entries from the ARP table , enter the following
command:
clear ip arp vlan <vid>
To clear route entries associated with the specified VLAN, enter
the following command:
clear ip route vlan <vid>
To clear specified QoS statistics, enter the following command:
clear qos policy-stats [<policy-id>]
To clear port statistics from the switch counters, enter the following
command:
clear ports stats [<ports>]
To end a specified Telnet session, enter the following command:
clear telnet <session id>
Nortel Ethernet Routing Switch 8300
Troubleshooting
NN46200-704 01.01 Standard
4.0 29 October 2007
Value
The session ID. The valid values are 0 to 7.
vid is the VLAN ID. The valid values are 0 to
255.
—End—
Value
The ACE ID.
The ACL ID.
The policy ID.
Monitoring ports 137